Updating firmware past 23.46 can brick your device Massive Stator Support doesn't support firmware versions past 23.46
NOTE: There are many other 3rd party apps that are also compatible with the Focbox Unity
NOTE: If you go past firmware version 23.46 you won't be able to use those apps above & you will instead need to use the VESC® tool below, these below tools will also allow you to go to firmware 5.xx and above as they get released. You can use these tools with your Focbox Unity However, If you prefer the simplicity of the FOCBOX UI tools we recommend that you don't go past firmware version 23.46 as it is the last supported firmware compatible with those tools.
The Focbox Unity is fully compatible with the VESC® tool on android. So to sum it up, weird process, had to strip down the whole board for a motor change.The Focbox Unity Dual Motor Controller is natively supported in the core VESC® firmware. I mean after all the metr module is connected to the secondary stormcore, like uh the one that gives me the error even with motor calibration when connected to either wired or wirelessly. bottom line for this particular board, I got the recommendation to just get an old android to have less headaches in the future. one of the two non-greyed out then worked, I set up both, which I guess does not make any sense but doesn’t hurt either (fingers crossed). actually I’m still not sure why this time the ppm calibration was not greyed out, maybe because I physically connected the right stormcore to the computer for the motor detection prior? when back at metr, the first two vesc had selectable ppm calibration, the other two were still greyed out. it took some fiddling, and it’s not really straight forward process, but it seems like everything worked out, now for the test-ride. I managed to get the motor detection working with vesc tool via osx, and did the rest in metr connecting to the right stormcore, so ppm calibration.
0 kommentar(er)
